Whirlpool Stove Error Code F1 E0 | Reason and Fix
Any electronic appliances are prone to face technical issues at a point regardless of their classification or purpose, especially those that have dedicated error or fault codes provided by the manufacturers. This is why you can find an error code list for modern smart appliances ranging from computers to washing machines, no matter what brands they belong to. The same goes with Whirlpool kitchen stoves and the 4-digit F1-E0 error code refers to a specific error – EEPROM Communication Error.
In this post, we’re going to talk about the Whirlpool stove error code F1-E0 in detail including the reason and relevant fix. So, take a few minutes and read the entire post.
Why Does Whirlpool Stove Show Error Code F1-E0?
Basically, the F1-E0 represents a communication error at any part of the stove’s electronics. In simple words, the code means that there’s an issue with the electrical units (which is EEPROM in most cases) that are causing a communication error or terminating the user’s command. It mainly happens when one or more keys are pressed for too long, or the control board becomes faulty.
How to Fix the Error Code F1-E0 on Whirlpool Stove?
Luckily, the fix for this error is pretty simple. All you need to do is power cycle the stove. Interesting, isn’t it? In case you don’t know about the power cycle procedure, don’t worry. Just follow the steps mentioned below accordingly –
Step 1: Turn off the circuit breaker or unplug the stove from the electrical outlet. This will shut down the power unit of the stove.
Step 2: Wait for 30 to 60 seconds at least.
Step 3: Now, turn on the circuit breaker or plug the stove into the electrical circuit in order to turn on the stove’s power unit.
(This process of turning a power-consuming component off and then turning it on again is known as a power cycle)
Step 4: Next, check the stove for at least a minute after power restoration to see whether the display shows the error code or not.
Step 5: If not, check the cooking operation of the stove for final verification.
Step 6: If so, that means the error still persists. In this situation, the best solution is to replace the entire control board.
Bonus Tips
There are some other 4-digit error codes that can also be fixed by power cycling. Those are –
- F1-E1: EEPROM Checksum Error
- F1-E2: UL A/D Error(s)
- F1-E4: Model ID Error
- F1-E5: Calibration Shifted
- F1-E6: Latch Signal Mismatch Error
- F1-E9: Stack Overflow
Conclusion
As you’ve read this far, we can assume that now you have a clear concept of what are the causes behind this error and which simple fix is capable of fixing it. As you can see, there’s no hassle while applying this fix except for turning on and off the power unit. Power cycle has proven itself an effective fix in this case for most users, so most likely it’ll do the job in your case too. If it unfortunately fails (the chances are low), consider replacing the control board with a new one. Last but not least, if this post proves useful, don’t forget to share your valuable opinion in the comment section.
